6 Answers About Diesel Exhaust Fluid

Cummins Fleetguard Diesel Exhaust Fluid

You have questions about Diesel Exhaust Fluid (DEF), and we have answers. 

Pick Up Diesel Exhaust Fluid (DEF) Nearby

With the addition of Selective Catalytic Reduction (SCR) to Cummins diesel engines for a wide range of vehicles built in 2010 or newer, we’ve answered some of the most common questions about Diesel Exhaust Fluid (DEF).

Here are answers to 6 frequently asked questions about DEF:

Q1: Where can I find DEF?

A: Because almost all diesel-powered passenger cars and trucks built since 2010 are equipped with Selective Catalytic Reduction (SCR) and require Diesel Exhaust Fluid (DEF), it is readily available at most fueling stations and automotive parts retail stores. Truck stops often have a DEF pump right on the fuel island. You can also get DEF at major OEM locations, including Cummins dealer and distributor locations. If you have a large enough fleet and the storage capacity to justify bulk purchasing, your fuel supplier may be able and willing to supply DEF to you directly.

Cummins Filtration has partnered with Old World Industries as the exclusive manufacturer, packager, and distributor for Fleetguard® Diesel Exhaust Fluid in North America.

For a comprehensive list of DEF retailers, visit DiscoverDEF.com. There you can see local facilities that carry DEF, and even enter a trip and map out all sources for DEF along your route.

Q2: What’s the shelf life of DEF?

A: DEF shelf life depends on the temperature of your storage facility. It is recommended that DEF be stored between 12°F and 86°F, but when stored below 65°F, shelf life is extended to 2 years. It is recommended to store DEF in a climate-controlled environment and out of direct sunlight to extend shelf life. 

Q3: What happens if DEF freezes?

A: While DEF does freeze at 12 degrees F, frozen DEF does not impact the start-up or operation of the vehicle.  Upon engine start-up, the SCR system provides heat to the DEF tank and lines which allows the DEF to thaw rapidly and keeps it flowing to the aftertreatment system regardless of the outside temperature.

Diesel Exhaust Fluid is formulated with 32.5 percent urea and 67.5 percent deionized water. In storage or when the engine is not in use, DEF will freeze at 12°F (-11°C). At this concentration level, the urea and the water freeze and thaw at the same rate – ensuring that you always have the correct amount of each. Engines with SCR are specifically programmed for optimal performance at this ratio, which is why it is important to make sure you get a quality brand of DEF that meets ISO specifications.

There is one operational difference to note: Like any water-based fluid, DEF expands when it is frozen (by approximately 7 percent). In cold weather, when the operator shuts the vehicle down, waiting 60 seconds before turning off the battery will allow the fluid to drain back out of the hoses and into the DEF tank.

No anti-gelling additive or freeze point improver should ever be added to the DEF, as they will impede its ability to perform correctly and may damage SCR system components.

Q4: How much DEF will my equipment use?

A: DEF consumption will vary depending on the environment, operation and duty cycle of the equipment you are using. On average, DEF consumption is 3-5% of your total fuel consumption levels.

Since most DEF fill-ups will take place at the same time as you are getting diesel fuel, it’s helpful to look at usage from that perspective. Our recommendation is to simply top off your DEF tank each time you refuel. If you are running a vehicle that gets very low actual activity, or the vehicle is stored in high ambient temperatures, where shelf life might be a concern, adjust your DEF refills accordingly and consider having a spare bottle of DEF available.

Q5: What happens if my equipment runs out of DEF?

A: All EPA 2010 engines with SCR are designed with a gauge that shows the DEF fluid level, similar to a fuel gauge. In addition, they are equipped with a system of flashing lights to alert the operator well in advance when the DEF tank is getting low on fluid. If the reservoir is not replenished with DEF and runs low, vehicle speed will be limited, but as soon as DEF is added, the engine will resume normal speed levels. A prudent measure would be to have a top-off gallon jug of DEF available on each piece of equipment with an EPA 2010 engine with an aftertreatment system.

Engines manufactured before July 8, 2011, may behave differently than described above. Talk to your local Cummins representative for more details, and ask for Cummins Bulletin 4971316, “Driver Tips For Fire And Emergency Vehicles." 

Q6: Does my equipment use a DEF filter?

A: Yes, all Cummins SCR systems come equipped with a DEF filter located in the DEF tank.

DEF filters help keep unwanted contaminant out of your SCR equipment.  If DEF is not properly filtered, urea crystals and other contaminants gained during transport and storage can cause the SCR system to malfunction or not work properly. Using Fleetguard DEF filters will help you prevent plugged DEF dosing valves and enable the Cummins SCR equipment to reduce harmful NOx emissions as intended. The Fleetguard UF101 filter can be used on any 2010-2016 Cummins engine with an SCR system. For 2017 and newer Cummins engines, such as the X15, use the Fleetguard UF106 filter. For more information about DEF filtration for today’s engines, visit https://www.cumminsfiltration.com/DEF_Urea

Learn More About Cummins Engines

 

Cummins Office Building

Cummins Inc.

Cummins, a global power technology leader, is a corporation of complementary business segments that design, manufacture, distribute and service a broad portfolio of power solutions. The company’s products range from internal combustion, electric and hybrid integrated power solutions and components including filtration, aftertreatment, turbochargers, fuel systems, controls systems, air handling systems, automated transmissions, electric power generation systems, microgrid controls, batteries, electrolyzers and fuel cell products.

Cummins Custompaks are being used for water management as Thailand struggles with its water crisis

CustomPak on site

Water crisis

Sixty Cummins Inc. CustomPaks are in service in Thailand as part of a critical water management plan aimed at easing the country’s water crisis – a crisis that has caused enormous economic and social damage and stirred conflict among communities.

Over the past several decades, Thailand has continually faced water problems caused by severe drought. Water reserves in dams and reservoirs are insufficient while water resources are often contaminated with toxins caused by urban communities and the industrial and agricultural sectors.

Severe flooding is a threat, too, at a time when the realities of climate change are hanging over the country.

As a result, the allocation of precious water resources, which must be shared among various stakeholders including new and existing industry, large and small agriculture, and cities and villages has become a flashpoint.

Kittithanapat Engineering Co. (KTP), has been involved in the water management system since 1996, working closely with authorities such as the Royal Irrigation Department, Department of Water Resources, Bangkok Metropolitan Authority and others.

CustomPaks on site

600 hp CustomPaks

To help KTP meet its often urgent requirements, Cummins DKSH (Thailand) has recently supplied 60 Australian-built CustomPaks – 45 powered by Cummins’ X15 engine rated at 600 hp, and 15 powered by the QSL9 rated at 325 hp. These fully self-contained powerpacks are emissions certified to Tier 3.

The CustomPaks are coupled to hydraulically-driven, large-volume submersible water pumps sourced by KTP from US company Moving Water Industries (MWI); KTP is the exclusive distributor in Thailand for these MWI Hydroflo pumps.

Prior to Cummins’ involvement, KTP was using another diesel engine brand but service support wasn’t up to the standard required.

Long-serving KTP engineer Kittisak Thanasoot says Cummins DKSH’s reputation for technical and aftersales support along with the reliability of the Cummins product were a key reason behind KTP’s decision to specify the CustomPaks for the Royal Irrigation Department.

The ability of Cummins DKSH to respond to short delivery times was also important.

“Supplying large quantities of high horsepower diesel engines for emergency situations such as flash flooding can be a challenge for KTP,” says Kittisak Thanasoot.

“Responding to the needs of the government agencies to manage such problems in a timely manner and with least impact on communities, KTP has found the answer in our partnership with Cummins DKSH.”

Power, pride and passion

Parked semi truck

The switch back to Cummins power has been beneficial for iconic New Zealand company Uhlenberg Haulage. It's all about whole-of-life costs.

Uhlenberg Haulage is closing in on 60 years in business, having been founded in 1966 by Mike and Carol Uhlenberg.

Based in Eltham, Taranaki, in New Zealand’s North Island, the operation is today owned and operated by their sons Chris, Daryl and Tony Uhlenberg.

Describing the Uhlenbergs as “old school family truckies”, Daryl talks about the company’s time-honored journey with a definite tone of pride, especially the work of his parents in laying the foundations for what is today an iconic fleet in its own right.

Cummins Inc. made its debut in the Uhlenberg fleet in 1971 with an NH250 powering a second-hand Kenworth K923 used in logging. A second Kenworth, a new W924 with a Cummins NTC335, followed soon after hauling an LPG tanker.

The Uhlenberg operation today comprises 40 prime movers and a variety of trailing gear to cater for the myriad of a jobs the fleet is involved in.

A number of Peterbilts feature in the fleet although Kenworth is now the brand of choice with six new units to be delivered over the next 12 months to cater for business growth.

Cummins’ X15 Euro 5 engine rated at 550 or 600 hp is the preferred power specification, with 18 red engines currently in the fleet.

Uhlenberg family in front of truck

Whole-of-life support

“The switch to Cummins has been a very good experience for us. We have nothing but praise for the Cummins organization,” says Daryl.

“The whole-of-life picture is the key thing for us and we’ve got that nailed with the support we get from Cummins – parts availability, scheduled maintenance, life expectancy and in-frame rebuilds.

“So the red engines turn up, we run them to life, which is 900,000 to 1.2 million kilometers, and then Cummins does an in-frame overhaul in a timely manner. If there’s an issue, parts and support are close by.

“The support we get from Cummins Palmerston North is fantastic, second to none.”

Daryl recently looked under a Kenworth that was in the workshop for a service and was surprised to see no oil leaking from the one-million-kilometer X15. “I remember when I was a fitter we had to wear a raincoat when working under a truck,” he jokes.

Fuel agnostic

Acknowledging that the push to decarbonize is now “very real”, Daryl likes the idea of Cummins’ fuel agnostic concept where one base internal combustion engine, optimized to run on diesel, can also be customized to run on ultra-low and zero-carbon fuels like renewable natural gas and hydrogen.

“My father was a pioneer of linehaul trucking in New Zealand and he always embraced new technology. He was never scared of it,” he says.

“I tend to be a little more cautious but I can see where a 500 hp natural gas or hydrogen engine would work for us in short haul applications,” he admits. “We’re certainly willing to look closely at these alternative fuel technologies when suitable infrastructure is in place.”

Redirecting to
cummins.com

The information you are looking for is on
cummins.com

We are launching that site for you now.

Thank you.